With printed Extrusions, I can test fit the size without having to cut anything, and if I do have to cut anything, I'm intentionally using the vertical layer lines to give me easy to cut/snap weak points along the layer lines.
This allows me to prototype with the 2020 Extrusion for cheap!
I suppose this is one of the few times the overly-tall vertical height of a Delta is actually handy hahah, that being said it is a v400, so I gotta ask...
Have you made sure to remove the dangerous [verify heater] section of the klipper config? Stock, flsun /effectively/ disable TRP using it.
Comments
With printed Extrusions, I can test fit the size without having to cut anything, and if I do have to cut anything, I'm intentionally using the vertical layer lines to give me easy to cut/snap weak points along the layer lines.
This allows me to prototype with the 2020 Extrusion for cheap!
Have you made sure to remove the dangerous [verify heater] section of the klipper config? Stock, flsun /effectively/ disable TRP using it.
So glad I'm only just now finding out about this!!
Thanks FLSun