Trying my hand at 3d printing keycaps to be used on the StrataPad.
My custom dye sub from Signature Plastics cost me about $10.25 per board since this is pretty low quantity.
3D printed costs me under 10 cents per set.
Not as much detail as dye sub caps, but it's close enough.
My custom dye sub from Signature Plastics cost me about $10.25 per board since this is pretty low quantity.
3D printed costs me under 10 cents per set.
Not as much detail as dye sub caps, but it's close enough.
1 / 3
Comments
Multicolor is just a layer swap at the start of later 3. No MMU or AMS
It does have me wanting to get an MMU for full flat letters though. And a 0.2mm nozzle for stem and legend details.
Trade-off, certainly, but I'm pretty pleased with these.