gts.amd.im
Another fedizen :fedi: from the Pacific Northwest of the USA. This is my private GoToSocial :gts: instance.
:cc: :cc_by: :cc_sa:
[bridged from https://gts.amd.im/@amd on the fediverse by https://fed.brid.gy/ ]
395 posts
23 followers
6 following
Prolific Poster
Conversation Starter
comment in response to
post
Donna is unimpressed by it.
#dogsofmastodon
comment in response to
post
@ariatheroyal before I went to buy parts it’s probably worth trying to cold pull the nozzle (if it’s possible on that design) and tearing down a bit to look for clogs or heat creep.
Cleaning your extruder drive gears would probably not hurt either.
comment in response to
post
The device that shows up is listed as: `ID 1a86:8091 QinHeng Electronics USB HUB`, no change is apparent after doing the RESET + BOOT0 dance.
comment in response to
post
@VeroniqueB99
Except there are…by a huge margin.
Tragically, 1.87 Canadas voted for trump in the last election.
@renardboy
comment in response to
post
@daihard I have a Salsa Fargo that gets basically all my bike path miles now because my roadie just isn’t as fun to ride at a social pace.
Upright, steel, 48mm supple tires from reneherse…It’s a pleasure cruise.
comment in response to
post
@ifixcoinops I’m not a big metafilter person but AIUI @jessamyn converted it to a nonprofit.
comment in response to
post
@swift GtS definitely has a stronger focus on consent and privacy.
The defaults are better, it has excellent features like block list subscriptions, and they’re pushing for things like reply controls and other features that will improve the
comment in response to
post
@outofcontrol I’m running minio and it works great for me.
comment in response to
post
@sabik i was sure this was going to be up-surgery, down-surgery, left-surgery, right-surgery, b-surgery, a-surgery
comment in response to
post
I’m digging through pics from the weekend and this pride train a kid made seems appropriate for this post.
comment in response to
post
@dfyx paramount3d does but frankly, though their colors are beautiful, I don’t love their PLA. I find it to be very brittle.
It would work for a one-off small project though.
https://www.paramount-3d.com/pla
comment in response to
post
Printed out a test block.
The thread ribs on their default settings feel perfect.
The bridged overhangs worked well even with the thread ribs screwing with the geometry a bit.
The teardrop shape worked but didn’t come out as clean as the bridged roof which […]
[Original post on gts.amd.im]
comment in response to
post
@projectgus i don’t know how well you know your mate but the concern I always have with a DIY someone else built is whether the electrical work is sound.
Did they properly ferrule connectors? Are all the wires rated well? Is the SSR high quality and being used well within its limits? Is there a […]
comment in response to
post
@mntmn the high contrast black and pink and black and yellow are great!
comment in response to
post
@rrmutt PLA is terrible about mechanical creep. Some nylons (PA6) are too.
Try the same experiment with PETG or ASA and you’ll have better results.
comment in response to
post
@reiver a cname would make a lot of sense and isn’t any harder to set up than the `did` process already is.